The Leader in Water Heater Repair in Jacksonville, FL, and the Surrounding Areas

When the drain valve is loose, water slowly leaks out—an easy fix with a wrench. Alternatively, leaks from the base of the valve mean the valve isn’t watertight, which requires a new drain valve. Homeowners and plumbers are both able to perform this task.

If too much pressure exists in the tank, the water leaks through cracks, loose parts, and more. If the water temperature is set too high, the pressure increases. Additionally, if the water from the water supply enters the system at high pressure, the tank experiences leaks.

In a similar vein, water heater leaks occur from problems with the temperature and pressure relief valve, or the T&P valve. Issues with the T&P valve result in higher water pressure. In addition, the valve loosens and causes leaks.

Water heaters have one tank with two shells. If a leak occurs on the inner shell because of age or deterioration, it isn’t plainly visible on the outside.

Rust develops over time, which leads to corrosion and leaks. If the water heater is at the end of its life, it’s best to replace it to avoid full failure and flooding.

If sediment rests at the bottom of the tank for extremely long periods of time, the tank deteriorates. When this type of leak occurs, the water heater needs replacement. It’s important to clean the tank on an annual basis to avoid this.

The inlet and outlet connections loosen over time, which causes leaks. These connections require tightening to fix the issue.

When the rod completely corrodes, water is able to leak through the area. Quick replacement takes care of this leak, so be sure to check the anode rod for excessive corrosion.

In glass-lined models, minerals calcify and collect in the tank, which causes cracks and leaks. Plus, heat expands water and this expansion stresses the glass and creates cracks.